移動式自動上料攪拌車使用中出現罐體停轉是怎么回事？ - 行業資訊_自動混凝土攪拌機知識-山東山汽工程機械（集團）有限公司

站內搜索

自動混凝土攪拌機知識

公司新聞行業資訊

熱點推薦

如何避免全自動攪拌車堵料的問題？

2022-02-18

想要開好自拌混凝土攪拌車下面幾條規矩不能少！

2021-02-26

自動上料攪拌車開機前需要做哪些準備工作？

2021-07-12

如何辨別自動上料攪拌車濾芯好壞

2022-04-27

關于山汽

聯系人：劉老師

電話：400-879-1999

公司：山東山汽工程機械（集團）有限公司

地址：山東省萊州市206國道與308省道交叉口東南50米

移動式自動上料攪拌車使用中出現罐體停轉是怎么回事？

所屬分類：行業資訊發布時間：2021-07-22 來源：http://www.shhuanlv.com/ 瀏覽量：18

現在移動式自動上料攪拌車在大型的建筑行業必不可缺少的，我們在大路上也是可以看見的，攪拌車就算是在行駛的路上也要進行不停的旋轉，若是不旋轉的話，里面的混凝土可以能就會結塊，當我們在一次使用的話就得先清理大塊的結塊了，這樣對攪拌車的本身也是不作好的，但是有的時候攪拌車在出現故障的時候攪拌車的罐體突然就停止轉動了，這是什么原因造成的呢？

Now the mobile automatic feeding mixer is indispensable in the large construction industry. We can also see it on the road. The mixer has to rotate continuously even on the road. If it doesn't rotate, the concrete in it will agglomerate. When we use it at one time, we have to clean up the large agglomerates, This is not good for the mixer itself, but sometimes when the mixer fails, the tank of the mixer suddenly stops rotating. What's the reason for this?

檢查攪拌葉片或者是側葉片與簡體內壁間有沒有大的異物，若是出現這樣的情況的話就就導致攪拌車的罐體停止運轉，若是有較大的異物也會導致攪拌軸停轉，所以能卡存異物，就是由于攪拌葉片或側葉片與罐內壁間隙過大造成的尤其是石子。
自動混凝土攪拌車

Check whether there is any big foreign matter between the mixing blade or side blade and the inner wall of the cylinder. If there is such a situation, it will cause the tank of the mixing truck to stop running. If there is a big foreign matter, it will also cause the mixing shaft to stop running, so the foreign matter can be stuck, which is caused by the large gap between the mixing blade or side blade and the inner wall of the tank, especially the stones.

檢查電機傳動皮帶有沒有出現松動的情況，若是攪拌罐車電機的皮帶過松的話就會導致傳遞的動力不足，所以就會導致罐體停止運轉的原因。

Check whether the motor drive belt is loose. If the motor belt of the mixing tank truck is too loose, it will lead to insufficient power transmission, so it will cause the tank to stop running.

觀察有沒有嚴重超載，若是攪拌車攪拌軸如果超過正常工作負荷，會使攪拌軸轉動緩慢，若負荷過大，就會導致攪拌軸停轉或者是攪拌軸彎曲，從而就會導致罐體停轉的現象。

Observe whether there is serious overload. If the mixing shaft of the mixer exceeds the normal working load, it will make the mixing shaft rotate slowly. If the load is too large, it will cause the mixing shaft to stop or the mixing shaft to bend, which will cause the tank to stop.

以上就是小編給大家講解的關于攪拌車使用中出現罐體停轉的原因的相關內容，通過小編的介紹大家在使用攪拌罐車之前要進行檢查哦，這樣大家在工作的時候才會減少故障的發生，還有就是大家在在裝混凝土的時候不要一味選擇多裝哦，我們要學會適可而止才可以哦，以免出現負荷的現象，這樣就會損壞攪拌車的哦，從而也會降低攪拌車的使用壽命。

The above is what Xiaobian explained to you about the causes of the tank stalling in the use of the mixer. Through Xiaobian's introduction, you should check before using the mixer, so that you can reduce the occurrence of faults when you work. In addition, you should not blindly choose to load more concrete, We should learn to stop just enough, so as to avoid the phenomenon of load, which will damage the performance of the mixer and reduce the service life of the mixer.

上一頁：混凝土車載4G視頻監控的作用有哪些？下一頁：自上料攪拌車如何確定給水量？

熱門產品 / HOT PRODUCT